C commands
CURSor:HBArs:UNIts
Group
Syntax
Arguments
Returns
80
Sets or queries the vertical scale units for the selected cursor source waveform.
Cursor
CURSor:HBArs:UNIts {BASe|PERcent}
CURSor:HBArs:UNIts?
BASe selects the vertical units for the selected waveform.
PERcent selects ratio cursors.
VOLTS indicates volts from ground as the unit of measure.
DIVS indicates divisions as the unit of measure, with center of screen as
0 divisions and bottom of screen as -4 divisions.
DECIBELS indicates decibels as the unit of measure, relative to a 1 V
wave. (FFT only)
UNKNOWN indicates that Trigger View is active. This also generates event
message 221. (Settings conflict)
AMPS indicates amperes as the unit of measure.
VOLTSSQUARED indicates volts squared (V*V) as the unit of measure.
AMPSSQUARED indicates amperes squared (A*A) as the unit of measure.
VOLTSAMPS indicates voltage times current (V*A) as the unit of measure.
NOTE. Unknown units are represented by "" in the instrument readouts.
sine
rms
TBS2000 Series Programmer