Ch<X>:Probe:id:type; Ch<X>:Probe:signal - Tektronix TBS2000 Series Programmer's Manual

CH<x>:PRObe:ID:TYPE?
Group
Syntax
CH<x>:PRObe:SIGnal
Group
Syntax
Arguments
TBS2000 Series Programmer
Returns the type of probe attached to the channel specified by <x>, where x is the
channel number. Level 2 (or higher) probes supply their exact product
nomenclature; for Level 0 or 1 probes, a generic "No Probe Detected message is
returned. Query Only.
Vertical
CH<x>:PRObe:ID:TYPE?
Examples
CH1:PROBE:ID:TYPE? might return :CH1:PROBE:ID:TYPE "P6203"
indicating that a P6203-type probe is attached to channel 1.
Sets or queries the input bypass setting of a TekVPI probe attached to channel
<x>, where x is the channel number. The probe must support input bypass, for
example TCP0001. This command is ignored if sent to an unsupported probe.
Vertical
CH<x>:PRObe:SIGnal {BYPass|PASS}
CH<x>:PRObe:SIGnal?
BYPass sets the probe to Bypass mode.
PASS sets the probe to Pass mode.
Examples
CH1:PRObe:SIGnal PASS set the probe attached to channel 1 to Pass mode.
CH1:PRObe:SIGnal? might return :CH1:PRObe:SIGnal PASS indicating that the
probe attached to channel 1 is in Pass mode
C commands
71