Servo With Coupler Function; Analogue Settings; Lgb® Pulse Sequence Mode - Esu LokPilot V4.0 Instruction Manual

Function outputs
You can connect 4 servos to the LokPilot XL V4.0, namely in par-
allel to AUX7 through AUX10. If you configure these outputs
to "Servo" then you should not use the corresponding physical
switching output at the terminal strip since it will be continuously
set to 100% and cannot be dimmed.
As one can see in the table Fig. 29 one must enter the desired
period as a multiple of 0.25 seconds into the "Brightness CV".
Enter the end position "A" into the "Special function CV 1" and
the end position "B" into the "Special function VC 2".

12.3.8.1. Servo with coupler function

One can also realise an automatic coupler function with a servo.
When you set the servo to the coupler mode called "Coupler func-
tion with servo" you can adjust the servo running time and the
end positions as described above. Furthermore CV 246, CV 247
and CV 248 are active as described in chapter 12.3.7.2.
62

12.4. Analogue settings

LokPilot V4.0 LokPilot V4.0 DCC
LokPilot micro V4.0 LokPilot micro V4.0 DCC
LokPilot XL V4.0
LokPilot Fx V4.0
With the CVs 13 and 14, you can predetermine which function
buttons should be switched in analogue mode. Thus, you „simu-
late" pressing an F button. The ex works default settings switch
on the directional headlights (F0 is on!) as well as F1 (ex works
allocated to AUX1).
Analogue Function Control 1
CV # F1 F2 F3
13 1 2 4
Analogue Function Control 2
CV # F0(f) F0(r) F9
14 1 2 4
12.5. LGB® Pulse Sequence Mode
LokPilot V4.0 LokPilot V4.0 DCC
LokPilot micro V4.0 LokPilot micro V4.0 DCC
LokPilot XL V4.0
LokPilot Fx V4.0
It is possible to switch to pulse sequence mode for operations with
the LGB® command station and the Roco® Lokmaus I. To do so,
set bit 5 in CV 49. From now on decoder counts the number of
times the F1 button is pressed in order to activate the desired func-
tion. Thus, it is possible to reach all function buttons by repeated
pushing of the F1 button.
LokPilot V4.0 M4
F4 F5 F6 F7
8 16 32 64 128
F10 F11 F12
8 16 32
LokPilot V4.0 M4
F8