Connecting C-Sine Motors („Softdrive-Sinus") - Esu LokPilot V4.0 Instruction Manual

Installing the Decoder
n.c. 1 22 Right track
n.c. 2 21 Left track
n.c. 3 20 GND
AUX4 4 19 Motor right
n.c. 5 18 Motor left
n.c. 6 17 n.c.
Rear light 7 16 Common (+)
Head light 8 15 AUX1
n.c. 9 14 AUX2
n.c. 10 13 AUX3
Index pin 11 12 VCC
How to connect the decoder:
Locomotive PCB
(Side view)
Locomotive PCB
(Side view)
Figure 3: LokPilots with 21MTC interface
6.5.1. Connecting C-Sine motors („SoftDrive-Sinus")
The LokPilot decoder cannot drive the newer Märklin® models
with C-Sine motors (also called „SoftDrive-Sinus") directly. To facil-
itate this, a circuit board supplied ex works with the locomotive is
required. This circuit board will be controlled by a LokPilot decoder.
Märklin® uses the 21MTC interface installed on this circuit board
and thus utilises the normal motor commands from the decoder or
a SUSU interface for the exchange of information.
The LokPilot V4.0 with the 21MTC interface is suitable for control-
ling the C-Sine control electronics provided some parameters are
set accordingly. Chapter 11.5. explains the necessary steps.
54614 LokPilot V4.0
54615 LokPilot V4.0
DCC
64614 LokPilot V4.0
M4
54621 LokPilot Fx
V4.0
Insert the decoder with connector
towards top
(e.g. Liliput®, ESU, HAG®,
Märklin®)
Insert the decoder with connector
towards bottom
(e.g. Brawa®)
AUX2 --
Right motor terminal --
Right track connection --
Rear light --
(blue) Common (+ pole) --
AUX1 --
Head light --
Left track connection --
Left motor terminal --
Head light 7 8 Motor +
Common (+ pole) 9 10 Motor -
Index pin 11 12 Right track
Rear light 13 14 Left track
16 AUX1
18 AUX2
- 1 2 (AUX3)
ZBCLK 3 4 ZBDTA
GND 5 6 -
Head light 7 8 Motor +
U+ 9 10 Motor -
Index pin 11 12 Right track
Rear light 13 14 Left track
- 15 16 AUX1
- 17 18 AUX2
(AUX4) 19 20 -
- 21 22 -
Figure 4: LokPilots with PluX interface
54616 LokPilot V4.0
64646 LokPilot V4.0 M4
PluX12
7
18
17
PluX16
56417 LokPilot V4.0
64617 LokPilot V4.0 M4
13