Programming With The Märklin® Mobile Station; Programming With The Märklin® Central Station - Esu LokPilot V4.0 Instruction Manual

Programming
8.2.4. Programming with the Märklin® Mobile Station®
LokPilot V4.0
LokPilot micro V4.0
LokPilot XL V4.0
With the Mobile Station®, you can also adjust some of the CVs.
Use the Register Programming Menu to facilitate this.
As with the 6021, you can only enter values between 1 and 80.
The possible CV values are also limited to that range from 1 to
80.
You will find the programming menu in the locomotive menu of
the Mobile Station®. It is only available for certain locomotives. Of
course, this works only for a programmable locomotive.
Proceed as follows:
• Enter a new locomotive in the database. How you do this is ex-
plained in the manual for the Mobile Station®.
• Select locomotive 36330. The locomotive Ex 3/3 is shown as active
on the display.
• By pressing the „MENU / ESC" button you can now change any of
the settings such as name, address, etc. in the heading „CHANGE
LOCOMOTIVE". The last function shown is „Register Program-
ming" (REG). Select this for writing CVs.
• Then select the CV (called „REG" on the Mobile Station®) and
then the desired value and confirm by pressing the change-of-
direction button.
• The Mobile Station® will program the new value into the de-
coder.
Please remove all locomotives which should not be programmed!
8.2.5. Programming with the Märklin® Central Station
LokPilot V4.0 M4 LokPilot V4.0
LokPilot micro V4.0
LokPilot XL V4.0
With the Central Station® until software version 2.04, you can
program the CVs 1 to 80 via the Motorola® programming menu.
Unfortunately, you can only enter values between 1 and 80. Find
more information regarding this programming mode in chapter 8
of the manual of the Central Station®.
Owners of a Central Station "Reloaded" or a Central Station 2
can program LokPilot decoders in DCC mode without any prob-
lems. With the CS1 "Reloaded" please proceed as described in the
manual in chapter 18 ("Decoder programming").
When using a Central Station 2, DCC programming is somewhat
trickier.
• Establish a new locomotive manually. This must be done even if
the decoder registers itself via mfx®. The locomotive address is not
important in this context.
• Call up the new "Dummy" locomotive with a throttle.
• Open the menu "Edit locomotive" and select type "DCC".
• Open the function "Edit locomotive".
• Now enter all CVs you wish to configure in the list. Only then the
command station will read out the values and save any changes.
LokPilot XL V4.0
The M4 capable decoders can be programmed directly via the de-
coder menu with all mfx® compatible command stations.
LokPilot V4.0 M4
LokPilot V4.0 M4
33