List Of All Supported Cvs; Dcc Decoders - Esu LokPilot V4.0 Instruction Manual

20. List of all supported CVs

20.1. DCC decoders

On the following pages, we have listed all CVs of LokPilot decoders in a chart. Please refer to the CV concept as outlined in chapter 5.1.
Please only change CVs if you are certain about their purpose and the impact of your action. Wrong CV settings can lead to impaired per-
formance or may cause your LokPilot not to respond at all.
CV Name
1 Loco address
2 Start voltage
3 Acceleration*
4 Deceleration
5 Maximum speed*
6 Medium speed*
7 Version number
8 Manufacturer's ID
13 Analogue mode F1-F8
14 Analogue mode FL, F9-F12
17 Extended address
18
19 Consist address
21 Consist Mode F1-F8
22 Consist Mode FL, F9-F12
68
Description
Address of engine (for LokPilot V4.0, LokPilot XL V4.0: Range 1 - 255)
Sets the minimum speed of the engine
This value multiplied by 0.25 is the time from stop to maximum speed
This value multiplied by 0.25 is the time from maximum speed to stop
Maximum speed of the engine
Medium speed of engine
Internal software version of decoder
Manufacturers's ID ESU - Writing value 8 in this CV triggers a reset to factory default
values
Status of functions F1 to F8 in analogue mode (see chapter 12.4.)
Status of function F0, F9 to F12 in analogue mode (see chapter 12.4.)
Long address of engine (see chapter 9.2)
Additional address for consist operation.
Value 0 or 128 means: consist address is disabled
1 – 127 consist address active, normal direction
129 – 255 consist address active reverse direction
Status of functions F1 to F8 in Consist mode
Meaning of the bits as in CV 13 (see chapter 12.4)
Status of functions FL, F9 to F12 in Consist mode
Meaning of the bits as in CV 14 (see chapter 12.4)
Range Value
1 - 127 3
1 - 255 3
0 - 255 32
0 - 255 24
0 - 255 64
0 - 255 22
- -
151 -
0-255 1
0-63 3
128 - 192
9999
0-255 0
0-255 0
0-63 0
* not for LokPilot Fx V4.0