Programming With The Esu Lokprogrammer; Programming With The Roco® Multimaus - Esu LokPilot V4.0 Instruction Manual

Programming
However, not all decoder options may be available in this mode.
This compromise is necessary in order to serve all mfx® command
stations on the market.

8.2.6. Programming with the ESU LokProgrammer

LokPilot V4.0 LokPilot V4.0 DCC
LokPilot micro V4.0 LokPilot micro V4.0 DCC
LokPilot XL V4.0
The LokProgrammer 53451 offers the easiest and most comfort-
able way of setting the CVs of LokPilot decoders: simply by a few
mouse clicks on an MS-Windows® computer. The computer saves
you to look for the various CV numbers and values. More informa-
tion is contained in the manual for the LokProgrammer.
You can access all properties of ESU decoders with the LokPro-
grammer. Since this works independently form the data format it
also works for mfx® decoders.
Please use the software version from V4.3.0 onwards for the Lok-
Pilot V4.0 decoder. The software is available for download on our
website!
8.2.7. Programming with the ROCO® Multimaus
LokPilot V4.0 LokPilot V4.0 DCC
LokPilot micro V4.0 LokPilot micro V4.0 DCC
LokPilot XL V4.0
Due to a severe firmware error the current LokPilot V4.0 decoder
cannot be programmed with the Multimaus - firmware 1.00. In
this case you must return your Multimaus to your dealer or directly
to the ROCO® service for an update to version 1.02 or a newer.
Unfortunately the ROCO® Multimaus® is not able to programm
any CVs via number 255 due to an error in the current (State:
Dec. 2010) firmware version 1.02. To make, however, a proper
programming procedure possible, we implemented an assistance
34
tool. This helps to write the number of the CVs desired temporarily
into two assisting CVs (so-called address registers), since the usual
CVs cannot be reached.
Afterwards the value of the CV desired will be programmed into
another assisting CV (so-called value register). When the value
LokPilot V4.0 M4
register is written, the content will be copied to the actual desired
position and the assisting CV will be set back.
Consequently, 3 CVs have to be programmed to write one CV.
These 3 CVs mean the following:
CV
96
97
99
Example: You wish to programm CV 317 with value 120.
Proceed as follows:
• Programm the value of the CV number in hundreds in CV 96. In
LokPilot V4.0 M4
this example: CV 96 = 3.
• Programm the value of the CV number in units and tens in CV 97.
In our example: CV 97 = 17.
• Programm the desired value in CV 99. In our example: CV 99 =
120.
As soon as you have programmed CV 99, the value of CV 99 will
be transferred into CV 317. Is the programming finished, CVs 96,
97 and 99 will be set back automatically.
Name Description
Address offset Saves the CV number that
should be actually programmed
in hundreds.
Address Saves the CV number that
should be actually programmed
in units and tens.
Value Saves the value of the CV that
should be actually programmed.
Value range
0 – 9
0-99
0-255