Wiring Diagram For Lokpilot Xl Decoders; Wiring To Lgb® Gear Boxes - Esu LokPilot V4.0 Instruction Manual

Wiring diagram for LokPilot XL

6.8.4. Wiring diagram for LokPilot XL decoders

DC Motor
Left track
Right track
6.8.4.1. Wiring to LGB® gear boxes
The decoder can wired directly to suitable LGB® locomotives with
the LGB® interface cable. Motor, light and auxiliary functions can
be controlled. The cable with the part number 55026 is available
from LGB®. Remove the dummy plug from the interface cable
16
Motor +
Motor -
UVAR
+5V
U+
Wheel sensor
GND
Figure 9: Wiring diagram for LokPilot XL V4.0 (wiring example)
U+
Head light
Rear light
AUX1
AUX2
AUX3
AUX4
AUX5
AUX6
IMP IMP
+5V
+5V
GND GND
and screw the ends into the terminals of the decoder after having
removed the insulation at the ends of the wires. Set the DIP switch
at the interface according to the instructions from LGB®.
Non-compliance may lead to the destruction of the decoder!