Removing And Installing Sealing Flange At Drive Plate End - Volkswagen Touareg 2003 Workshop Repair Manual

Touareg 2003 ➤
8-cylinder injection engine - Edition 11.2011
– Screw locking pin -3242- into crankshaft.
– Loosen drive plate securing bolts diagonally and remove.
– Remove drive plate together with washer and shim.
Installing
Installation is carried out in the reverse order. When installing,
note the following:
– Fit shim -1- of „2.0 mm thickness" onto crankshaft journal.
– Then, install drive plate and washer -2- of „3.4 mm thickness".
– Insert new securing bolts and tighten by hand.
– Tighten securing bolt to 30 Nm +
may be performed in several steps.)
– Unscrew locking pin -3242- .
– Install sealing plug with a new seal. Specified torque: 35 Nm
2.3 Removing and installing sealing flange
at drive plate end
Removing ⇒ page 25 .
Installing ⇒ page 25 .
Special tools and workshop equipment required
♦ Fitting tool -T10122-
♦ Torque wrench (5...50 Nm) -V.A.G 1331-
24
Rep. gr.13 - Crankshaft group
1
/ 4 turn (The additional turn