Removing And Installing Camshafts And Variable Camshaft Timing Adjusters - Volkswagen Touareg 2003 Workshop Repair Manual

Touareg 2003 ➤
8-cylinder injection engine - Edition 11.2011
– Unscrew bolts -1- from Hall sender.
– Unscrew bolt -2- from rear of toothed belt guard.
– Slightly pull rear of toothed belt guard towards front and re‐
move Hall sender housing with Hall sender screen and taper.
Continuation for both cylinder heads
– Screw in pin -2085/1- as shown in the illustration.
– Unscrew inner part of oil seal extractor -2085- several turns
out of the outer part and lock with knurled screw.
– Lubricate threaded head of oil seal extractor, place it in posi‐
tion and, exerting firm pressure, screw it into oil seal as far as
possible.
– Loosen knurled screw and turn inner part against pin -2085/1-
until seal is pulled out.
– Clamp flats of oil seal extractor in vice. Remove oil seal with
pliers.
– Then press in new seal to stop until it is flush using fitting
sleeve -3241/1- and bolt -3241/3- .
Further assembly is basically the reverse of the dismantling se‐
quence.
2.4 Removing and installing camshafts and
variable camshaft timing adjusters
Removing ⇒ page 57 .
Installing ⇒ page 59 .
Special tools and workshop equipment required
56
Rep. gr.15 - Cylinder head, valve gear