2.3.1
Removing
– Remove engine
⇒ page 3
– Separate engine from gearbox.
– Remove drive plate
– Remove sump
⇒ page 70
– Remove sealing flange -arrow- from cylinder block.
– Remove existing gasket.
2.3.2
Installing
Note
In the following work procedure the seal is illustrated without
♦
sealing flange.
If repair is required, sealing flange and seal must be renewed
♦
completely. Use protective sleeve supplied when installing.
– Clean sealing surfaces on sealing flange and cylinder block.
They must be free of oil and grease.
– Remove oil residue from crankshaft journal using clean cloth.
– Fit new gasket -1- onto dowel sleeves on cylinder block.
.
⇒ page 22
.
.
8-cylinder injection engine - Edition 11.2011
2. Removing and installing sealing flange and drive plate
Touareg 2003 ➤
25