Removing And Installing Sealing Flange And Drive Plate; Assembly Overview - Volkswagen Touareg 2003 Workshop Repair Manual

2 Removing and installing sealing
flange and drive plate
Note
Secure engine to engine and gearbox support -VAS 6095- to car‐
ry out repairs.

Assembly overview

⇒ page 21
Removing and installing drive plate
Removing and installing sealing flange at drive plate end
⇒ page 24
Renewing crankshaft oil seal, vibration damper end
⇒ page 26
2.1 Assembly overview
1 - Gasket
❑ Renew.
2 - Sealing flange
❑ With seal.
❑ Remove sump in order
to remove and install
⇒ page 70 .
❑ Must seat on dowel
sleeves.
❑ Before installing, re‐
move oil residue from
crankshaft journal using
a clean cloth.
❑ Do not additionally oil or
grease the oil seal seal‐
ing lip.
❑ Use support sleeve sup‐
plied when installing.
❑ Only remove supporting
sleeve after sealing
flange has been slid on‐
to crankshaft journal.
❑ If the sealing flange has
not been renewed use
fitting tool -T10122- for
installing ⇒ page 26
Removing and installing
sealing flange at drive
plate end.
❑ Removing and installing
⇒ page 24 .
3 - Shim
❑ 2 mm thick
4 - Drive plate
❑ Use locking pin -3242- to loosen and tighten
5 - Washer
❑ 3.4 mm thick
.
⇒ page 22 .
,
8-cylinder injection engine - Edition 11.2011
⇒ page 22 ; Removing and installing drive plate.

2. Removing and installing sealing flange and drive plate

Touareg 2003 ➤
21