Table of Contents
Advertisement
REMOTE 1
USB interface connector. Use a USB-A to USB-B cable (not supplied) to connect your PC.
The USB driver can be downloaded from the following URL:
http://www.ftdichip.com/ftdrivers.htm
Click "VCP Drivers", then select the device number "FT232B"
REMOTE 2
RS-232C serial interface connector. Use a DB-9 serial cable to connector your PC.
(Caution: The REMOTE 1 and the REMOTE 2 cannot be used simultaneously.)
INTERNAL SPEAKER (TOP PANEL)
Internal speaker
ACC CONNECTOR PIN ASSIGNMENT
This connector provides output for audio and the discriminator, or for other applications
you might create. Refer to the pin assignment indicated in the chart below.
PIN NUMBER
1
2
3
4
5
6
7
8
Note: Values for pins 2, 6, 7 are for a FM 3KHz deviation at antenna input level.
RACK MOUNT
There are four (4) screw holes (unused), two (2) on each side on the cabinet. They are a
provision for rack mount application. Size of the screw is M4 x 8.
.
CONNECTION
5V DC @30mA max.
Discriminator output (500mV p-p)
10.7MHz IF output
NC
NC
AF out (H) 120mV @ 600 ohm
AF out (L) 60mV @ 600 ohm
Ground
8
Advertisement
Table of Contents
