AOR SR2000A Instruction Manual page 57

Acquisition: PP<CR>
PQ Priority function switch
Setup: PQn<CR>
Acquisition: PQ<CR>
PR Pass frequency read
Acquisition: PRmm<CR> mm = 01 ~ 40 (search bank)
PW Pass frequency setting (normal search)
Setup: PWnnnn.nnnn<CR>
QS Search bank delete
Setup: QSnn<CR>
RF Monitor receive frequency
Setup: RFnn.nn<CR>
Acquisition: RF<CR>
RQ Noise squelch
Setup: RQn<CR>
Acquisition: RQ<CR>
RS Reset
Setup: RS<CR>
This command does not delete search bank or memory channels.
The receiver needs to restart after executing this command.
RW Spectrum frequency resolution step
Setup: RWn<CR>
Acquisition: RW<CR>
RX RFU (Receiver unit) status read
Acquisition: RX<CR>
In the memory channel mode:
MR MXmnn GAn RFmmmm.nnnn STmmm.nn MDn ATn AMn TMxx...
In the memory scan mode:
MS MXmnn GAn RFmmmmmnnnn STmmmnnn MDn SQn ATn AMn TMxx...
In the select memory channel mode:
nn = 00 ~ 99 (memory channel)
Response value : PPmnn
n = 0 (off)
n = 1 (on)
Response value : PQn
Response value : If no frequency is registered in the
PRmm nnnn.nnnn (MHz) list, the only response will be "OK".
nnnn.nnnn (MHz)
If no frequency is specified, the present frequency will be
chosen. Command valid only for setup.
nn = 01 ~ 40 (search bank) Command valid only for setup.
(Note: The pass frequencies inside the search bank will also be
deleted.)
nn.nn = 25 ~ 3000 (MHz)
Response value : RFnnnn.nnnn (MHz) (fixed length)
nn = 0 ~ 72 Default : 0
Response value : RQnn (fixed length)
Command valid only for setup.
n = 0 (1KHz)
n = 1 (4KHz)
n = 2 (32KHz)
n = 3 (64KHz)
n = 4 (128KHz) Default : 2
Response value : RWn
Response values are as follows:
(Unit: RF: in MHz, ST: in KHz)
(Unit: RF: in Hz, ST: in Hz)
56