Table of Contents
Advertisement
INDICATOR FOR SELECTED FREQUENCY
This memory scan behavior depends on the squelch delay time (between squelch closing
and scan restart) set in the "configuration menu" in paragraph 7. If you wish to bypass
the configured delay settings, press the MHz key to force detection to the next higher
frequency, or press the KHz key to the next lower frequency.
You can pick up any of the detected frequencies and copy it to the VFO screen for live
analysis. To do so, select the desired frequency with the white triangle by using the UP
soft key or the DOWN soft key, then press the SET FREQ. soft key. The VFO mode will
be in the same state as just before you entered in the memory scan mode.
8-3 Programming the memory
In either the VFO mode or the Memory read mode, access the memory programming page
by pressing the MHz key for two seconds, or by pushing the FUNC key followed by the 3
key for one second. Use the UP and DOWN soft keys to scroll through the page.
To force the next signal detection:
Press the MHz key for scanning up.
Press the KHz key for scanning down.
To copy a frequency onto the VFO:
Select the frequency with the UP or
DOWN soft keys.
Press the SET FREQ. soft key.
34
Advertisement
Table of Contents
