Table of Contents
Advertisement
Use the UP and DOWN soft key to move from one section to the other.
Once the desired selection appears in reverse contrast, rotate the dial knob to do any
changes as needed, and press the MHz key to go to the next section. Be aware that your
changes have not been saved so far! Once you have finished the desired configuration
changes, press and hold the MHz key for one second to save all your settings and return
to the screen you were at before entering the configuration.
Press the CLR key to escape from the configuration menu without saving your changes.
You will return to the screen you used before entering the configuration screen.
To access the configuration menu:
Press the FUNC key, then press the 9 key.
Use the UP and DOWN soft keys to go to the desired selection.
Rotate the dial knob to apply changes.
To go to the next selection, press the MHz key.
To save your all changes, press and hold the MHz key for one
second.
To cancel the configuration without saving any changes, press the
CLR key.
DELAY TIME
Sets the delay in seconds, between squelch closing and scan restart. Default setting is 2.
Setting possibilities are "OFF" (scan resumes immediately), a range from 0.1 ~ 9.9, and
HOLD (does not continue scan).
FREE
Sets the delay in seconds, between the squelch opening and scan restart. Default setting is
OFF.
Setting possibilities are OFF and 0.1 ~ 9.9. This feature is rarely used and should be set to
OFF.
30
Advertisement
Table of Contents
