Table of Contents
Advertisement
MKR-OUT (Marker data output)
The frequency and signal level which the marker I reading, can be output as data to the
serial port. "ON" enables this feature. Default setting is "OFF".
NTSC/PAL
Select the receive video format to display on the LCD and video out from the rear connector.
Default setting is NTSC.
To receive in SECAM format, select PAL.
V. FREQ
Select the audio frequency on the video signal to the monitor frequency or the audio signal
frequency (video frequency – 2.645 MHz).
Default setting is AUDIO.
If there is an adjacent interfering signal near the receive frequency and causes the decoding
problem, then set it to AUDIO (video frequency – 2.645 MHz). In that case, select the
V.FREQ DIR to NORMAL.
V.FREQ DIR
Some video transmitters utilizes the reversed frequency shift modulation in order to
set signals scrambled. If the signal is reversed, select the V.FREQ DIR to REVERSE.
Default setting is NORMAL.
In the AM video mode, select NORMAL.
V.H-POS
This function is to adjust the horizontal position of the external video monitor.
Default setting is 16.
V.SYSTEM
Select the video format to NTSC, PAL, or SECAM.
Default setting is AUTO.
To receive in SECAM format, select AUTO or PAL.
BEEP
The SR2000A emits confirmation "beeps" when the keypad is used. Default is ON.
Beep level is not adjustable.
PLOT (Drawing mode setup)
Set to PAINT as default. The OUTLINE setting has the monitor only drawing the outline
of the displayed wave.
DEF-DIAL (Dial automatic return), DIAL-TIME (Dial return timing)
The dial knob is used to tune 4 main functions which are frequency (FREQ), marker (MKR),
Squelch (SQL) and AF gain (VOL). The DEF-DIAL selections allows you to set one of the
31
Advertisement
Table of Contents
