3 Connections
Connect your antenna to the connector labeled "ANT", and an external speaker,
if required, to the connector labeled "EXT.SP". The speaker should have a power handling
capability of 2 watts or greater.
Where possible, use the supplied AC/DC power unit. Connect the supplied power unit to the
wall outlet and its DC cable to the "DC 12V" connector on the rear panel.
4. Power switch
To switch on the SR2000A, press once to latch the switch in.
4-1
Start-up
After connecting the AC/DC power unit, switch on the power switch. The opening screen will
briefly display the AOR logo, model number, firmware version and make a short
"beep" sound. This start-up sequence is a factory default and cannot be altered.
4-2
Powering down
To switch off the SR2000A, press the power switch a second time, the switch releases and
the unit is powered down. Interfering with the regular powering down process might damage
the SR2000A.
5 Operations of the SR2000A
5-1 Display
This section explains what you can expect to see on the SR2000A monitor screen using the
VFO seek mode in the spectrum operation mode.
Once the SR2000A is properly connected, the display will appear on the screen.
9