Table of Contents
Advertisement
RECEIVE MODE FREQUENCY STEP
By pressing the soft key below CENTER FREQ. on the LCD, the center frequency is selected
and can be adjusted using the dial knob.
Key entry of the main frequency:
Enter the frequency in MHz format using the numeric keys, then press the
MHz key to complete.
Frequency Step:
Once the frequency on the LCD is selected, the frequency step that applies is
the receiver frequency step.
If the CENTER FREQ. is selected, the frequency step that applies is the display step.
In the plot on above, the frequency step would be 31.250KHz.
This value is not displayed in the Spectrum Analyzer mode.
Rotating the dial knob clockwise increases the frequency, rotating it counterclockwise
decreases it.
In the diagram below, the Step Resolution mode is active. The center frequency
being selected (in reverse contrast), the dial knob now controls the display step.
MONITOR FREQUENCY
(10 MHz/320=31.250KHz)
14
Advertisement
Table of Contents
