Table of Contents
Advertisement
SELECTED LETTER
Up To 12 CHARACTERS CAN BE
ENTERED HERE
Soft keys (<=, DEL, = =>)
The soft keys <= = and = => allow you to go to the previous/next character, while DEL
soft key deletes the selected character.
Character input
A set of character is assigned to each numeric keys, as displayed on the monitor. For
example, when you press the 2 key, the assigned characters come as follows:
A
B
C
a
When a different key is pressed, the cursor goes automatically to the next character.
[Note]: The text input method of the SR2000A is very similar to cellular
phones.
Saving your changes
To save your text input, press the MHz key, which will bring you to the Memory Programming
Page (previous paragraph 8-3). Remember to press and hold the MHz key again for 2
seconds to save all your changes.
To save your text input:
Press the MHz key.
To leave this screen without saving any changes:
Press and hold the CLR key for 2 seconds.
8-5 Selected memory scanning
The Selected Memory Scanning function allows you to scan only a selection of frequencies
which were previously saved as memory channels. A maximum of 100 channels within a
bank can be scanned.
b
c
2
A
.....
36
Advertisement
Table of Contents
