AOR SR2000A Instruction Manual page 59

SQ Squelch
Setup: SQn<CR>
Acquisition: SQ<CR>
SR Search bank read out
Setup: SRnn<CR>
Response value :
SRnn SLnnnnnnnnnn SUnnnnnnnnnn MDn SQn ATn AMn TTxx....
(Note: Refer to the SE command for details.)
SS Normal search mode
Setup: SSmm<CR>
Command valid only for setup.
ST Frequency step (except search)
Setup: STnnn.nnn<CR>
Acquisition: ST<CR>
SV Copy search data to VFO
Setup: SVn<CR>
Command valid only for setup.
TF Start frequency
Setup: TFmm.nn<CR>
Acquisition: TF<CR>
(Note: Depending on the center frequency and the spectrum frequency span, some
value cannot apply.)
TI Priority interval time
Setup: TInn<CR>
Acquisition: TI<CR>
TL Spectrum peak trigger
Setup: TL-nn<CR>
Acquisition: TL<CR>
TS FFT frequency setup
Setup: TSnn<CR>
n = 0 (noise squelch)
n = 1 (level squelch)
Response value : SQn
nn = 01 ~ 40 (search bank number)
mm = 01 ~ 40
The search bank number must always be two digits.
nnn.nnn = 0.1 ~ 100.0 (KHz), 6.25 (KHz), 8.33 (KHz)
Response value : STnnn.nnn
n = 0 ~ 8, n = 0 (VFO-A)
n = 1 (VFO-B)
n = 2 (VFO-C)
n = 3 (VFO-D)
n = 4 (VFO-E)
n = 5 (VFO-F)
n = 6 (VFO-G)
n = 7 (VFO-H)
n = 8 (VFO-I)
m.n = 20 ~ 2999.92 (MHz)
n for 100Hz designated value
Response value : TFnnnn.nnnn (MHz)
nn = 1 ~ 20 (second) Default : 5
Response value : TInn
nn = 0 ~ 99 Between TL and nn, the minus sign (-) is necessary.
Default : -90
Response value : TL-nn
nn = 2 ~ 12,
nn = 2 (5KHz)
nn = 3 (6.25KHz)
nn = 4 (8.33KHz)
Default : 0
Default :10
Default : 0 (VFO-A)
58