Table of Contents
Advertisement
Memory read indicator
First, select the desired memory bank and channel using the numeric keys. The first
single digit number will be the bank and second 2 digit number will be the channel.
If you enter an incorrect parameter, an error beep will sound.
Alternatively you can use the dial knob to select the desired bank number and channel.
In case the memory bank/channel indicator is not selected by reverse contrast, press the
FREQ. key. Note that bank switching like that found on a common scanner is not possible.
by the numeric keys:
Example:
You would like to recall the memory bank "0" with the memory channel "09":
Press the 0, 0, 9 keys
By rotating the dial knob, either left or right, browse through the existing memory
banks/channels.
To select the memory bank/channel by reverse contrast:
Press the FREQ. key.
8-2 Memory scan
To scan the frequencies which are stored in the bank/memory channels, press the
FUNC key, then press the 3 key. As in the plot below, the frequencies of the detected
signals (according to the squelch settings) are listed on the screen. The screen is
overwritten by the 31
until the operation mode is changed (such as VFO) or the screen is overwritten with new
frequencies, or the power is switched off.
Memory bank and channel
Memory description text
st
frequency. The displayed (maximum 30) frequencies are stored
33
Advertisement
Table of Contents
