Setting Up The Receive Mode; Audio Gain Control - AOR SR2000A Instruction Manual

6-1-2 Setting up the receive mode

To change the receive mode, press the MODE key. The receive mode icon will be selected (in
reverse contrast) on the LCD to confirm that the mode select menu has been activated.
The following 4 modes are available with the SR2000A: NFM, WFM, SFM, AM.
Receive mode setup:
Press the MODE key.
Rotate the dial knob to select the desired mode.
Press the MHz key.
When an optional APCO25 (P25) board is installed, select the NFM mode to monitor APCO25
(P25) signal in convention mode.

6-1-3 Audio Gain Control

Pushing the VOL key will select the volume indicator on the LCD (in reverse contrast). You can
then adjust the AF gain by rotating the dial knob.
RECEIVE MODE
IF filter bandwidth for each receiving mode
RECEIVE MODE IF filter bandwidth
WFM
NFM
SFM
AM
300KHz
15KHz
6KHz
6KHz
16