AOR SR2000A Instruction Manual page 53

FF FFT search
Setup: FFmm TSnn TT-kk<CR>
FP Spectrum frequency setup
Setup: FPm.n<CR>
Acquisition: FP<CR>
FS Spectrum display setup
Setup: FSm.n<CR>
Acquisition: FS<CR>
GA Select memory
Setup: GAn<CR>
Acquisition: GA<CR>
(Note: This command cannot be used alone, it must be associated with MA, MX or RX
commands. However, in the memory channel mode, this command can be used
alone.)
GD Graph download
Acquisition: GD<CR>
Output the level data of each frequency on the screen.
Response: GD<SP><CR><LF>/<SP><CR><LF>
(Example)
F0083.0000L-100<SP><CR><LF>
F0083.0312L-100<SP><CR><LF>
---
F0092.9375L-100<SP><CR><LF>
F0092.9787L-100<SP><CR><LF>
/<SP><CR><LF>
(Note: The separator (/<SP><CR><LF>) has 320 lines. When the level data indicates other
than 320, the SR2000A is in the channel scope mode. The level data depends on
the start, step, and end frequencies.)
GN Spectrum/Video input sensitivity
Setup: GNn<CR>
Acquisition: GN<CR>
FFmm : mm = 01 ~ 40 (search bank number)
TSnn:
TS-nn:
TT-kk: -kk refers to TT
Command valid only for setup
m.n = 0.16 ~ 10 (MHz)
n for 1 KHz designated value
Response value : FPmm.nnn (fixed length)
(Note: Does not apply with FFT search)
m.n = 0.5 ~ 31.25 (KHz)
n for KHz designated value
Response value : FSmm.nnn (fixed length)
(Note: Does not apply with FFT search)
n = 0 (release)
n = 1 (registration)
Response value : GAn
n = 0 (0dBm))
n = 1 (-10dBm)
n = 2 (-20dBm)
n = 3 (-30dBm)
n = 4 (-40dBm)
n = 5 (-50dBm) Default : 4
Response value : GNn
nn refers to TS
-nn refers to TT
Default : 10
Default : 31.25
Default : 0
52