Table of Contents
Advertisement
1-3 Power requirements
The SR2000A may be provided with a suitable AC/DC power unit. The SR2000A is designed for
operation from a nominal 12 V DC regulated power supply (12 to 14 V is acceptable), which
should be capable of supplying a minimum of 1.5 amp continuous, ideally a 2 amp power supply
unit should be used.
[Note: Never connect the SR2000A directly to an AC outlet.]
[Safety Notice: Always disconnect the power supply from the AC outlet when not in use.]
Should the SR2000A appear to behave strangely, normal operation may be resumed by resetting
the microprocessor. Please refer to section "6. Configuration" for further information.
1-4 Supplied accessories
The following accessories are provided in the shipping box.
1
Instruction manual (this booklet)
1
AC adapter
1-5 Features
FFT (Fast Fourier Transform) high speed display
The FFT search function enables incredibly high speed signal monitoring, 10MHz search
in approximately 0.07 seconds!
Displays up to 40MHz of spectrum bandwidth
Up to 40 MHz of bandwidth can be displayed in real time through advanced Digital Signal
Processing. (No audio is available when the frequency span is set to 20MHz or 40 MHz)
5 inch TFT color LCD display
5 inch TFT color display is easy to monitor the clear, crisp images of received signals.
Waterfall (time) display function
Tracks signals over time and uses colors to define their strength.
Average or peak value readings
Frequency coverage
25 MHz ~ 3 GHz (Cellular Blocked for US consumer version)
Ultra-stable, high sensitivity triple conversion receiver
AM/NFM/WFM/SFM receive modes
Video display mode (NTSC, PAL, and SECAM format)
1000 memory settings
100ch x 10 memory banks
Easy menu-driven operation
PC control through serial port or USB interface
APCO25 (P25) decoder (Optional decoder board required)
4
Advertisement
Table of Contents
