AOR SR2000A Instruction Manual page 55

MC Change marker frequency to center frequency (CF)
Setup: MC<CR>
MD Demodulation mode
Setup: MDn<CR>
Acquisition: MD<CR>
ME Median value
Setup: MEn<CR>
Acquisition: ME<CR>
MF Marker frequency
Setup: MFm.n<CR> m.n = 20 ~ 3005 (MHz)
Acquisition: MF<CR>
MI Marker level read out
Acquisition: MI<CR>
MO Marker data read
Setup: MOn<CR>
Acquisition: MO<CR>
(Note: When the spectrum is displayed, the commands MF and FD are
sequentially executed every time the spectrum data is updated.)
MQ Memory channel delete
Setup: MQmnn<CR> m = 0 ~ 9 (bank number)
MR Memory read mode
Setup: MRmnn<CR> m = 0 ~ 9 (bank number)
MS Memory scan mode
Setup: MSn<CR>
MU Mute
Setup: MUn<CR>
Acquisition: MU<CR>
MX Memory data setting
Setup: MXmnn GAn RFnnnn.nnnn MDn ATn AMn TMxx...<CR>
MXmnn: m = 0 ~ 9 (bank number)
Command valid only for setup.
n = 0 (NFM)
n = 1 (WFM)
n = 2 (SFM)
n = 3 (AM) Default : 0
Response value : MDn
n = 2 ~ 4 Default : 4
Response value : MEn
n for 100Hz designated value.
However, m.n will depend on the center frequency and
frequency span. The initial value is as for CF.
Response value : MFmmmm.nnnn (MHz) (fixed length)
Response value: MInnn
Nnn = -99 ~ 0 (dB)
n = 0 (no output)
n = 1 (output active) Default : 0
Response value : MOn
nn = 00 ~ 99 (channel number)
Command valid only for setup.
nn = 00 ~ 99 (channel number)
Command valid only for setup.
n = 0 ~ 9 (bank number)
Command valid only for setup.
n = 0 (mute off)
n = 1 (mute on) Default : 0
Response value : MUn
54