Table of Contents
Advertisement
While in the Search mode, press the FUNC key followed by the MODE key to access
the PASS mode, then as in the plot above, the frequency 147.86 MHz is selected from
the search result list by the white triangle cursor (with the UP or DOWN soft keys),
and set as a PASS FREQUENCY by pressing the SET FREQ. soft key.
Each bank accepts up to 50 pass frequencies. An error beep will sound if you try to
register more than this maximum.
(Note) 1. Up to 30 out of 50 pass frequencies are displayed on the screen at a time.
2. This function is not available in the FFT search mode.
Frequency Pass Browser menu
In the VFO mode or the search mode, press the FUNC key followed by a two seconds of the
MODE key press, to access the frequency pass browser screen.
All pass frequencies of the designated search bank will be listed.
Delete pass frequencies
Use the UP or DOWN soft keys to move the white cursor to the frequency you wish to erase,
and press the DEL soft key to delete the entry.
To leave this screen without saving any changes:
10-4 FFT Search
FFT search differs from regular scanning methods (one frequency / step after the other) in
that It provides a spectrum "image" up to 10 MHz wide, sampled 15 times per second.
10-4-1 Search banks and FFT search
Although the search bank basic step for normal search and FFT search are done the same
way (for L-FREQ, H-FREQ and text settings)，in FFT search, however, the following
Press the CLR key.
43
Advertisement
Table of Contents
