RX SX 125
Removing the idle gear
•
Remove the magneto flywheel.
•
Slide off the starter motor gear.
See also
Magneto flywheel removal
Fitting the idle gear
•
Rotate the engine support so that it
faces upwards, flywheel side.
•
Apply MOLYKOTE 111 to all the bear-
ing housings and the teeth of the start-
up gear unit.
•
Install the start-up gear unit together
with the thrust washer in the hole with
the needle bearing.
Generator side
Removing the flywheel cover
•
Lean the engine on the support in such
a way as to place the start-up cover
facing upwards.
•
Undo and remove the six screws fixing
the flywheel cover.
Engine
ENG - 95