APRILIA SX 125 Service Station Manual page 157

RX SX 125
•
Take the pumping member rod fully out
of the sleeve cartridge.
•
Insert the spring keeping the pumping
member rod in place.
•
Insert an open key under the lock nut
to support the pumping member rod
and the spring.
•
Screw the spring until it is fully inserted
into the sleeve end.
•
Place the spring preloading pipe.
•
Screw the upper locking cap on the
pumping member stem.
•
Screw the fork upper cap up to the
pumping member stem.
•
Place the upper cap on the sleeve tak-
ing care not to damage the O-ring.
•
Tighten the upper cap to the prescribed
torque.
Suspensions
SUSP - 157