Reassembling The Fork - APRILIA SX 125 Service Station Manual

RX SX 125
•
Check the sliding surface for scorings and/or scratches. These scorings can be eliminated
by rubbing them with wet sandpaper (grain 1).
•
If the scorings are deep, replace the stem.
•
Use a dial gauge to check that the stem bending is below the limit value.
•
If over the value, replace the stem.
Bending limit: 0.2 mm
CAUTION
A BENT STEM SHOULD NEVER BE STRAIGHTENED BECAUSE ITS STRUCTURE WOULD BE
WEAKENED AND USING THE VEHICLE MAY BECOME DANGEROUS.
•
Check that there are no damages and/or cracks; otherwise, replace it.
•
Check that the sliding bushings are in good conditions.
•
If there are signs of excessive wear or damage, replace the affected component.
CAUTION
REMOVE ANY IMPURITY IN THE BUSHINGS, TAKING CARE NOT TO SCRATCH THEIR SUR-
FACE.
Replace the following components with new ones:
- sealing ring;
- dust guard;
- O-ring gasket on the cap.

Reassembling the fork

•
Check the components.
CAUTION
BE EXTREMELY CAREFUL IN ORDER THAT NO FOREIGN BODIES GET INTO THE SLEEVE OR
THE WHEEL HOLDER STEM.
NEVER REUSE OIL.
NOTE
SPREAD A THIN LAYER OF FORK OIL ON GASKETS AND BUSHINGS BEFORE REFITTING
THEM.
•
Lock the sleeve on a vice in a horizon-
tal position.
•
Tighten the bottom screw.
Suspensions
SUSP - 153