RX SX 125
•
To exit, turn the key to OFF.
CONFIGURATION OF WHEEL SIZE ON IN-
STRUMENT PANEL
The first time the RX125 - SX125 instrument panel
is switched on, it must be configured according to
the correct wheel size.
Upon switching on, the instrument panel is as
shown in the figure.
Briefly press the MODE button in the instrument
panel and the screen corresponding to the 1891
mm (74.45 in) size for the SX125 model is dis-
played.
Briefly press the MODE button in the instrument
panel and the screen corresponding to the 2066
mm (81.34 in) size for the RX125 is displayed.
In order to configure the instrument panel, press the MODE button until the letters WS are shown on
the LCD on the right-hand bottom side.
Now remove and insert the key again. The instrument panel will first turn on the warning lights and the
active segments on the LCD. Afterwards, it will display the pre-set wheel size value and then it will shift
to regular operation.
Recovery procedure
If an incorrect wheel size value has been configured, the instrument panel can be brought back to the
correct configuration.
The procedure is as follows:
•
remove the key
Electrical system
ELE SYS - 53