Terminal Functions; Device Configuration - Texas Instruments TMS320C6748 Manual

www.ti.com
3.7

Terminal Functions

Table 3-5 to Table 3-31
mechanical package designator, the pin type (I, O, IO, OZ, or PWR), whether the pin/ball has any internal
pullup/pulldown resistors, whether the pin/ball is configurable as an IO in GPIO mode, and a functional pin
description.
3.7.1 Device Reset, NMI and JTAG
SIGNAL
NAME
RESET
NMI
RESETOUT / UHPI_HAS / PRU1_R30[14] /
GP6[15]
TMS
TDI
TDO
TCK
TRST
EMU0
EMU1
(1) I = Input, O = Output, I/O = Bidirectional, Z = High impedance, PWR = Supply voltage, GND = Ground, A = Analog signal.
Note: For multiplexed pins where functions have different types (ie., input versus output), the table reflects the pin function direction for
that particular peripheral.
(2) IPD = Internal Pulldown resistor, IPU = Internal Pullup resistor. CP[n] = configurable pull-up/pull-down (where n is the pin group) using
the PUPDENA and PUPDSEL registers in the System Module. For more detailed information on pullup/pulldown resistors and situations
where external pullup/pulldown resistors are required, see the
internal pulldown circuits, see the
(3) This signal is part of a dual-voltage IO group (A, B or C). These groups can be operated at 3.3V or 1.8V nominal. The three groups can
be operated at independent voltages but all pins withina group will operate at the same voltage. Group A operates at the voltage of
power supply DVDD3318_A. Group B operates at the voltage of power supply DVDD3318_B. Group C operates at the voltage of power
supply DVDD3318_C.
(4) Open drain mode for RESETOUT function.
Copyright © 2009–2017, Texas Instruments Incorporated
identify the external signal names, the associated pin/ball numbers along with the
Table 3-5. Reset, NMI and JTAG Terminal Functions
(1)
TYPE
NO.
RESET
K14 I
J17 I
(4)
T17 O
L16 I
M16 I
J18 O
J15 I
L17 I
J16 I/O
K16 I/O
Device Operating Conditions
Submit Documentation Feedback
Product Folder Links:
SPRS590G – JUNE 2009 – REVISED JANUARY 2017
POWER
(2)
PULL
(3)
GROUP
— B Device reset input
IPU B Non-Maskable Interrupt
CP[21] C Reset output
JTAG
IPU B JTAG test mode select
IPU B JTAG test data input
IPU B JTAG test data output
IPU B JTAG test clock
IPD B JTAG test reset
IPU B Emulation pin
IPU B Emulation pin

Device Configuration

section. For electrical specifications on pullup and
section.
TMS320C6748
TMS320C6748
DESCRIPTION
Device Comparison 27