Installing A Wlan Or Wwan Module - Nexcom VMC 3000 User Manual

Chapter 2: System Setup

Installing a WLAN or WWAN module

Prior to removing the chassis cover, make sure the unit's power is off and
disconnected from the power sources to prevent electric shock or system
CAUTION! CAUTION!
CAUTION!
damage.
1. Remove these screws and put them in a safe place for later use.
Copyright © 2012 NEXCOM International Co., Ltd. All rights reserved
2. Remove the rear cover of the VMC 3000 series.
The Mini PCI Express slot shown below is used to install a WLAN
module or 3.5G communication module such as GPRS,
UMTS or HSDPA module.
3. Insert the module into the Mini PCI Express slot at a 45 degrees angle
until the gold-plated connector on the edge of the module completely
disappears inside the slot. And then attach RF cable to the module.
4. Install the rear cover.
30
For WLAN and
WWAN module
For WWAN module
VMC 3000/4000 Series User Manual