Installing A So-Dimm; Installing A Wwan Module - Nexcom VTC 1021 Series User Manual

Vehicle telematics computer

Table of Contents

Chapter 4: System Setup

Installing a SO-DIMM

1. Push the ejector tabs which are at the ends of the socket outward. Then

insert the module into the socket at an approximately 30 degrees angle.

Apply firm even pressure to each end of the module until it slips down

into the socket. The contact fingers on the edge of the module will

almost completely disappear inside the socket.

1. Locate the WWAN Mini PCI Express slot (CN10). Insert the module into the

Mini PCI Express slot at a 45 degrees angle until the gold-plated connector

on the edge of the module completely disappears inside the slot. Then

fasten screws into the mounting holes to secure the module.

Mounting

screws

VTC 1021 Series User Manual

Table of Contents

Vtc 1021-bk Vtc 1021-c2k