Selecting The Totalizer Units; Selecting The Mass Flow Units - GE XGS868 Programming Manual

Selecting the Totalizer
Units
Selecting the Mass Flow
Units
Programming Site Data
1. Use the pull-down menu to select the desired units for the totalized
flow rate display and press Next Item/Enter. Available units are
listed in Table 1-1 on the previous page.
2. Use the pull-down menu to select the desired number of digits to
the right of the decimal point in the totalized flow rate display and
press Next Item/Enter.
3. Do one of the following:
•
If MASS FLOW is ON, proceed to Selecting the Mass Flow
Units below.
If MASS FLOW is OFF, the meter returns to the Channel
•
PROGRAM window. Go to Procedure Options on the following
page.
Note: To activate mass flow, refer to page 1-20.
1. Use the pull-down menu to select the desired mass flow units for
the flow rate display and press Next Item/Enter. The available
units for this prompt are determined by the selection made at
System Units. See Table 1-2 below.
Table 1-2: Available Mass Flow Units
English
Pounds
Thousands of LB
Millions of LB
Tons (2000 LB)
2. Use the pull-down menu to select the desired time units for the
mass flow rate display and press Next Item/Enter.
3. Use the pull-down menu to select the desired number of digits to
the right of the decimal point in the mass flow rate display and
press Next Item/Enter.
4. Use the pull-down menu to select the desired units for the totalized
mass flow rate display and press Next Item/Enter. The available
units for this prompt are determined by the selection made at
System Units.
5. Use the pull-down menu to select the desired number of digits to
the right of the decimal point in the totalized mass flow rate
display and press Next Item/Enter.
November 2004
Metric
Kilograms
Metric Tons (1000 KG)
1-5