Entering System Data For A Channel/Path - Chx-Systm; Accessing The Chx-Systm Submenu; Selecting The Volumetric Units; Selecting The Totalizer Units - GE AquaTrans AT868 User Manual

Entering System Data for
a Channel/Path - CHx-
SYSTM
Accessing the CHx-SYSTM
Submenu
Selecting the Volumetric
Units
Selecting the Totalizer
Units
Programming Site Data
The CHx-SYSTM submenu is used to enter system parameters for the
individual channels/paths. When channels/paths operate separately,
the AT868 uses the system parameters in this menu. When channels/
paths are averaged together, the AT868 uses parameters selected in
the GLOBL-SYSTM submenu.
While following the programming instructions, refer to Figure A-1 on
page A-1 in Appendix A, Menu Maps. Remember to record all
programmed data in Appendix C, Data Records.
1. Press [ESC], [ENTER], [ESC]. The meter enters the user program.
2. Press [ ] until PROG appears and press [ENTER].
3. Press [ ] until the desired channel appears. Press [ENTER] at CH1
or CH2.
4. Press [ ] until SYSTM appears and press [ENTER].
5. Enter the desired CHANNEL LABEL (up to 5 characters) by using
the arrow keys. Press [
desired location and press
press [ENTER].
6. Use the arrow keys to enter the desired SITE MESSAGE (up to 16
characters) and press [ENTER]. (For a 2-channel/path meter, this
prompt is called CHANNEL MESSAGE.)
1. Use the arrow keys to select the desired volumetric units for the
flow rate display and press [ENTER].
2. Use the arrow keys to select the desired number of digits to the
right of the decimal point in the volumetric flow rate display and
press [ENTER].
1. Use the arrow keys to select the desired units for the totalized flow
rate display and press [ENTER].
2. Use the arrow keys to select the desired number of digits to the
right of the decimal point in the totalized flow rate display and
press [ENTER].
3. Do one of the following:
•
If MASS FLOW is ON and both channels are active (for
2-channel units only), proceed to Selecting Mass Flow Units on
page 2-4.
•
If MASS FLOW is OFF and/or only one channel is active, the
meter returns to the Channel PROGRAM window. Go to
Procedure Options on page 2-4.
Note: To activate mass flow, refer to page 2-20.
]
and [ ] to move the cursor to the
[ ] and [ ]
to change a letter. Then
September 2004
2-3