Entering Data In The Channel Menu; Selecting The Channel Measurement Method - GE DigitalFlow XMT868i Startup Manual

Chapter 2. Initial Setup

2.4 Entering Data in the Channel Menu

The menu is used to enter data specific to each channel. Refer to Figure 14 on page 45 and remember to
Channel
record all programming data in Appendix B, Data Records.
Note: In this manual, only the programming of Channel 1 will be described. To program Channel 2 of a 2-Channel
meter, simply repeat the same procedures presented for Channel 1.

2.4.1 Selecting the Channel Measurement Method

The submenu permits selection of the desired measurement method.
ACTIV
1. In the Keypad Program, scroll to
2. In the menu, scroll to the desired channel (
PROG
Note: In the 1-Channel XMT868i,
3. In the
Channel PROGRAM
4. The option offers two choices:
and press
[Enter]
Note: In the 1-Channel XMT868i,
The XMT868i returns to the
34
PROG
does not appear.
CH2
menu, scroll to
and
OFF
.
does not appear.
OFF
Channel PROGRAM
and press .
[Enter]
or ) and press
CH1 CH2
and press
ACTIV [Enter]
(Transit-Time). Scroll to the desired option for this channel
TRANS
menu. Scroll to the
SYSTM
[Enter].
.
option.
DigitalFlow™ XMT868i Startup Guide