Entering Setup Data; Set Transducer Signal Settings - GE XGS868 Programming Manual

Entering Setup Data

Set Transducer Signal
Settings
Procedure Options
Programming Site Data
The signal limits, response times, mass flow and multi K factors for
the Model XGS868 are specified via the
following four submenus are included in this section:
Signal - set the parameters related to the transducer signal
•
(see below).
V averaging - specify the response of the meter to step changes
•
(page 1-18).
Default Setup - reset all parameters to default values (page 1-18)
•
Advanced Features - enable mass flow and enter K factors
•
(page 1-19).
While following the programming instructions, refer to Figure A-2 in
Appendix A. Record all programmed data in Appendix B, Data
Records.
Use this option to set the limits for the incoming signal and other
parameters affecting the transducer signal. For example, the
programmed signal strength low limit may be used to determine the
trigger point for an alarm.
The Signal default settings are suitable for most
applications. Consult the factory before
changing any of these parameters.
Only after consulting the factory, complete the following steps to
program the signal parameters:
1. Open the SITE EDIT MENU from the Edit Functions menu.
2. Select Channelx.
3. Select Set up.
4. Select Signal.
5. Use Table 1-4 on the next page to choose the desired values. Enter
or select a value and press Next Item/Enter.
After completing the above steps, IDM returns to the Channel SET UP
window. Do one of the following:
•
To continue programming, refer to Appendix A, Menu Maps, to
navigate to the desired menu.
To leave the User Program, press Exit Page three times.
•
November 2004
Setup
submenu. The
Caution!
1-15