Table of Contents
Advertisement
November 2004
Setting Up the LCD
(cont.)
Procedure Options
2-2
8. Use the pull-down menu to select the desired channel option and
press Next Item/Enter.
9. Use the pull-down menu to select the desired measurement
parameter and press Next Item/Enter.
Note: The measurement units that appear in these prompts are those
Global-System
selected in the
10.Repeat Steps 8 and 9 until all of the specified
have been set up.
After leaving the User Program, the XGS868 will reset itself and will
begin to display the parameters specified in this section. If more than
one parameter was set up, each of the parameters will be displayed in
sequence, with a pause of several seconds between display changes.
After completing the above steps, IDM returns to the
Output
window. Do one of the following:
•
To continue regular programming, refer to Appendix A, Menu
Maps, to navigate to the desired menu.
To leave the User Program, press Exit Page three times.
•
window earlier in this section.
# OF LCD PARAMS
Global Input/
Displaying and Handling Data
Hide quick links:
Advertisement
Table of Contents
