GE XGS868 Programming Manual page 64

November 2004
Selecting the Log Channels
(cont.)
Selecting the Start Time
Selecting the Start Date
3-8
6. Use the pull-down menu to create a circular or linear log and press
Next Item/Enter.
A circular log records data continuously, but only the data from
the most recent log cycle is saved. The circular log begins
recording data at the specified START TIME and continues to record
data until a manual STOP command is issued. At the end of each
log cycle, as defined by the DURATION time, previously recorded
data is overwritten by the new data.
IMPORTANT:
If there is insufficient memory available to store a
specified log, setup of that log will not be permitted.
1. Use the pull-down menu to select the desired start time for the log
and press Next Item/Enter.
2. If you selected:
OK, proceed to Selecting the Start Date below.
•
EDIT, proceed to the next step.
•
NOW, press Next Item/Enter to acknowledge the message. You
•
have completed creating an error log.
3. Use the pull-down menu to select AM or PM. Then, enter the
desired hour (1-12) and press Next Item/Enter.
Note: If you enter a start time earlier that the current time and error
will occur.
4. Enter the desired minutes (0 to 59) and press Next Item/Enter.
5. Enter the desired seconds (0 to 59) and press Next Item/Enter.
1. Use the pull-down menu to select the desired start date for the log
and press Next Item/Enter.
2. If you selected:
OK or TODAY, proceed to Step 6.
•
EDIT, proceed to the next step.
•
3. Enter the desired year (0-99) and press Next Item/Enter.
4. Use the pull-down menu to select the desired month and press
Next Item/Enter.
5. Enter the desired day (1 to the number of days in the selected
month) and press Next Item/Enter.
Logging Data