GE XGS868 Programming Manual page 87

Using the RCCU (cont.)
Remote Control Communications Unit
To energize the RCCU, press the [ON] key on its keypad. The
RCCU's LCD display, which consists of 4 lines x 20 characters, will
be activated. See Figure C-2 on page C-2 for the layout of the RCCU
keypad and display.
For reliable RCCU communications, the infrared receiver in the
window of the XGS868 should have a clear line of sight to the RCCU
and should be located within 8 ft (2.5 m) of the RCCU with an angle
of incidence of no more than 15°.
Immediately upon activation, the RCCU will perform its normal
startup routine. This results in a display of the GE Panametrics logo,
followed by these informational displays:
GE Panametrics Inc.
--RCCU--
Remote Control
Communications Unit
Software Revision
RCCU R1B
F1 F2
IDM MENU START
IDM MENU
previous selection appears here
SYSTEM ONLINE
F1 F2
The RCCU is now ready for operation.
F3
GGGG When the startup routine has
been completed, this IDM
Menu Start display appears.
OFFLNE
F3
November 2004
C-5