Checking The Xgs868 Memory; Stopping A Log - GE XGS868 Programming Manual

Selecting the Start Date
(cont.)
Checking the XGS868
Memory

Stopping a Log

Logging Data
6. Press Next Item/Enter to acknowledge the message.
Note: To log more than six parameters, simply re-enter the Create
Error Log submenu as many times as necessary to set up
additional logs. Select the other desired parameters, and run
these logs simultaneously with the first log.
Use the Memory submenu to verify that the available log memory is
sufficient for the desired log. If the expected amount of logged data
will exceed the remaining memory capacity, the Model XGS868
suggests that some old logs be cleared to make room for the new log.
Refer to Figure A-5 in Appendix A.
Complete the following steps to set up an error log:
1. Open the LOG EDIT MENU from the Edit Functions menu.
2. Select Memory.
3. IDM displays the available memory. Press EXIT PAGE.
Use the Stop submenu to terminate a logging process that is currently
active. Refer to Figure A-5 in Appendix A.
Complete the following steps to set up an error log:
1. Open the LOG EDIT MENU from the Edit Functions menu.
2. Select Stop Logging.
3. Use the pull-down menu to find the desired log and press Next
Item/Enter.
Note: Once a log is stopped it cannot be restarted, but the log
remains in memory. To clear the log from memory, refer to
Deleting Files from the XGS868 Memory on page 2-5.
November 2004
3-9