GE XGS868 Programming Manual page 63

Selecting the Log Channels
Logging Data
1. Use the pull-down menu to select the desired channel option and
press Next Item/Enter.
2. Use the pull-down menu to select the desired measurement
parameter and press Next Item/Enter. See Table 3-1 below a list
of the available options.
Table 3-2: Output Measurement Options
Forward Totalized Volume Flow
Reverse Totalized Volume Flow
Total Flow Measurement Time
Forward Totalized Mass Flow
Reverse Totalized Mass Flow
Diagnostic Parameters
The DIAG* option listed in the table above represents all of the
individual diagnostic parameters that appear. See Chapter 3,
Diagnostics, of the Service Manual for a complete description of
these options.
Note: The measurement units that appear in these prompts are those
selected in the Global-System window earlier in this section.
3. Repeat Steps 1 and 2 until until all of the log channels have been
set up.
4. Do one of the following:
•
If you selected a totalized value, proceed to the next step.
•
If you selected a non-totalized value for the log and
selected FLASH as the log memory location, proceed to
•
Selecting the Start Time on the next page.
selected NVR or PCMCIA as the log memory location,
•
proceed to Step 6.
5. Use the pull-down menu to clear or keep current log totals and
press Next Item/Enter.
Note: Responding YES at the above prompt clears only the log
totals; it does not clear the meter totalizers. To reset meter
totals, see Clearing Totals on page 2-3.
Description
Flow Velocity
Volumetric Flow
Mass Flow
November 2004
3-7