Entering System Data For The Channel; Accessing The Channelx-System Submenu; Selecting The Volumetric Units - GE XGS868 Programming Manual

November 2004
Entering System Data for
the Channel
Accessing the Channelx-
System submenu
Selecting the Volumetric
Units
1-4
The Channelx-System submenu is used to enter system parameters
for the channel. While following the programming instructions, refer
to Figure A-1 in Appendix A.
1. Open the SITE EDIT MENU from the Edit Functions menu.
2. Select Channelx.
3. Select System.
4. Key in the desired Channel Label (up to 5 characters) and press
Next Item/Enter.
5. Key in the desired Site/Channel Message (up to 21 characters)
and press Next Item/Enter.
1. Use the pull-down menu to select the desired volumetric units for
the flow rate display and press Next Item/Enter. Available units
are listed in Table 1-1 below.
2. Use the pull-down menu to select the desired time units for the
flow rate display and press Next Item/Enter.
3. Use the pull-down menu to select the desired number of digits to
the right of the decimal point in the volumetric flow rate display
and press Next Item/Enter.
Table 1-1: Available Volumetric/Totalizer Units
English
Actual Cubic Feet
Thousands of ACF
Millions of ACF
Standard Cubic Feet
Thousands of SCF
Millions of SCF
Metric
Actual Cubic Meters
Thousands of ACM
Millions of ACM
Standard Cubic Meters
Thousands of SCM
Millions of SCM
Programming Site Data