Contact Outputs - GE C60 Instruction Manual

6.2 STATUS
PATH: ACTUAL VALUES

# CONTACT OUTPUTS

#
The present state of the contact outputs is shown here.
The first line of a message display indicates the ID of the contact output. For example, 'Cont Op 1' refers to the contact out-
put in terms of the default name-array index. The second line of the display indicates the logic state of the contact output.
For Form-A outputs, the state of the voltage(V) and/or current(I) detectors will show as: Off, VOff, IOff, On,
VOn, and/or IOn. For Form-C outputs, the state will show as Off or On.
NOTE
PATH: ACTUAL VALUES
# VIRTUAL OUTPUTS
#
The present state of up to 64 virtual outputs is shown here. The first line of a message display indicates the ID of the virtual
output. For example, 'Virt Op 1' refers to the virtual output in terms of the default name-array index. The second line of the
display indicates the logic state of the virtual output, as calculated by the FlexLogic™ equation for that output.
6
PATH: ACTUAL VALUES
# AUTORECLOSE 1
#
The automatic reclosure shot count is shown here.
PATH: ACTUAL VALUES
# REMOTE DEVICES
# STATUS
The present state of up to 16 programmed Remote Devices is shown here. The
cates whether or not all programmed Remote Devices are online. If the corresponding state is "No", then at least one
required Remote Device is not online.
6-4
! !"
STATUS CONTACT OUTPUTS
Cont Op 1
Off
Cont Op xx
MESSAGE
Off
! !"
STATUS VIRTUAL OUTPUTS
Virt Op 1
Off
Virt Op 64
MESSAGE
Off
! !"
STATUS AUTORECLOSE
AUTORECLOSE 1
SHOT COUNT:
! !"
STATUS REMOTE DEVICES STATUS
All REMOTE DEVICES
ONLINE: No
REMOTE DEVICE
MESSAGE
STATUS: Offline
REMOTE DEVICE 16
MESSAGE
STATUS: Offline
C60 Breaker Management Relay
↓
↓
!
AUTORECLOSE 1
Range: 0, 1, 2, 3, 4
0
Range: Yes, No
Range: Online, Offline
1
↓
Range: Online, Offline
ALL REMOTE DEVICES ONLINE
6 ACTUAL VALUES
6.2.4 CONTACT OUTPUTS
6.2.5 VIRTUAL OUTPUTS
6.2.6 AUTORECLOSE
6.2.7 REMOTE DEVICES STATUS
message indi-
GE Multilin