Installation - GE C60 Instruction Manual

5 SETTINGS
!
PATH: SETTINGS PRODUCT SETUP

# INSTALLATION

#
MESSAGE
To safeguard against the installation of a relay whose settings have not been entered, the unit will not allow signaling of any
output relay until
RELAY SETTINGS
leaves the factory. The UNIT NOT PROGRAMMED self-test error message is displayed automatically until the relay is put
into the Programmed state.
The setting allows the user to uniquely identify a relay. This name will appear on generated reports. This name
RELAY NAME
is also used to identify specific devices which are engaged in automatically sending/receiving data over the Ethernet com-
munications channel using the UCA2/MMS protocol.
GE Multilin
!"
INSTALLATION
RELAY SETTINGS:
Not Programmed
RELAY NAME:
Relay-1
is set to "Programmed". This setting is defaulted to "Not Programmed" when the relay
C60 Breaker Management Relay
5.2 PRODUCT SETUP
5.2.13 INSTALLATION
Range: Not Programmed, Programmed
Range: up to 20 alphanumeric characters
5
5-23