GE C60 Instruction Manual page 100

5.4 FLEXLOGIC™
Table 5–10: C60 FLEXLOGIC™ OPERANDS (Sheet 3 of 3)
OPERAND TYPE OPERAND SYNTAX
RESETTING RESET OP
RESET OP (COMMS)
RESET OP (OPERAND)
RESET OP (PUSHBUTTON)
SELF- ANY MAJOR ERROR
DIAGNOSTICS ANY MINOR ERROR
ANY SELF-TEST
LOW ON MEMORY
WATCHDOG ERROR
PROGRAM ERROR
EEPROM DATA ERROR
PRI ETHERNET FAIL
SEC ETHERNET FAIL
BATTERY FAIL
SYSTEM EXCEPTION
UNIT NOT PROGRAMMED
EQUIPMENT MISMATCH
FLEXLGC ERROR TOKEN
PROTOTYPE FIRMWARE
UNIT NOT CALIBRATED
NO DSP INTERRUPTS
DSP ERROR
IRIG-B FAILURE
REMOTE DEVICE OFFLINE
Some operands can be re-named by the user. These are the names of the breakers in the breaker control feature, the ID
(identification) of contact inputs, the ID of virtual inputs, and the ID of virtual outputs. If the user changes the default name/
ID of any of these operands, the assigned name will appear in the relay list of operands. The default names are shown in
the FLEXLOGIC™ OPERANDS table above.
5
The characteristics of the logic gates are tabulated below, and the operators available in FlexLogic™ are listed in the FLEX-
LOGIC™ OPERATORS table.
Table 5–11: FLEXLOGIC™ GATE CHARACTERISTICS
GATES
NOT
OR
AND
NOR
NAND
XOR
5-36
OPERAND DESCRIPTION
Reset command is operated (set by all 3 operands below)
Communications source of the reset command
Operand source of the reset command
Reset key (pushbutton) source of the reset command
Any of the major self-test errors generated (major error)
Any of the minor self-test errors generated (minor error)
Any self-test errors generated (generic, any error)
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
See description in the COMMANDS chapter.
NUMBER OF INPUTS
1
2 to 16
2 to 16
2 to 16
2 to 16
2
C60 Breaker Management Relay
OUTPUT IS '1' (= ON) IF...
input is '0'
any input is '1'
all inputs are '1'
all inputs are '0'
any input is '0'
only one input is '1'
5 SETTINGS
GE Multilin