GE C60 Instruction Manual page 73

5 SETTINGS
b) NETWORK
!
PATH: SETTINGS PRODUCT SETUP
# COMMUNICATIONS
#
# NETWORK
#
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
The Network setting messages will appear only if the UR is ordered with an Ethernet card. The Ethernet Primary and Sec-
ondary Link Monitor settings allow internal self test targets to be triggered when either the Primary or Secondary ethernet
fibre link status indicates a connection loss. The IP addresses are used with DNP/Network, Modbus/TCP, MMS/UCA2, IEC
60870-5-104, TFTP, and HTTP (web server) protocols. The NSAP address is used with the MMS/UCA2 protocol over the
OSI (CLNP/TP4) stack only. Each network protocol has a setting for the
only in advanced network configurations. They should normally be left at their default values, but may be changed if
required; for example, to allow access to multiple URs behind a router. By setting a different TCP/UCP Port Number for a
given protocol on each UR, the router can map the URs to the same external IP address. The client software (URPC, for
example) must be configured to use the correct port number if these settings are used.
Do not set more than one protocol to use the same TCP/UDP Port Number, as this will result in unreliable
operation of those protocols.
WARNING
When the NSAP address, any TCP/UDP Port Number, or any User Map setting (when used with DNP) is changed,
it will not become active until power to the relay has been cycled (OFF/ON).
NOTE
GE Multilin
!" !"
COMMUNICATIONS
IP ADDRESS:
0.0.0.0
SUBNET IP MASK:
0.0.0.0
GATEWAY IP ADDRESS:
0.0.0.0
# OSI NETWORK
# ADDRESS (NSAP)
ETHERNET OPERATION
MODE: Half-Duplex
ETHERNET PRI LINK
MONITOR: Disabled
ETHERNET SEC LINK
MONITOR: Disabled
C60 Breaker Management Relay
NETWORK
Range: Standard IP address format
Only active if CPU Type 9C or 9D is ordered.
Range: Standard IP address format
Only active if CPU Type 9C or 9D is ordered.
Range: Standard IP address format
Only active if CPU Type 9C or 9D is ordered.
Note: Press the MESSAGE
ADDRESS. Only active if CPU Type 9C or 9D is ordered.
Range: Half-Duplex, Full-Duplex
Only active if CPU Type 9C or 9D is ordered.
Range: Disabled, Enabled
Only active if CPU Type 9C or 9D is ordered.
Range: Disabled, Enabled
Only active if CPU Type 9C or 9D is ordered.
TCP/UDP PORT NUMBER
5.2 PRODUCT SETUP
!
key to enter the OSI NETWORK
. These settings are used
5-9
5