Mitsubishi Electric M700V Series Programming Manual page 76

6. Interpolation Functions
Command format
G07.1 C__ ;
C
(Note) The above format applies when the name of the rotation axis is "C". If the name is not "C",
command the name of the rotation axis being used instead of "C".
(1) The coordinates commanded in the interval from the start to cancellation of the cylindrical
interpolation mode will be the cylindrical coordinate system.
G07.1 C Cylinder radius value;
:
:
:
G07.1 C0 ;
(2) G107 can be used instead of G07.1.
(Cylindrical interpolation mode start/cancel)
: Cylinder radius value
• Radius value ≠ 0: Cylindrical interpolation mode start
• Radius value = 0: Cylindrical interpolation mode cancel
64
6.9 Cylindrical Interpolation ; G07.1
Cylindrical interpolation mode start
(Cylindrical interpolation will start)
(The coordinate commands in this interval will be the
cylindrical coordinate system)
Cylindrical interpolation mode cancel
(Cylindrical interpolation will be canceled)