Diameter Designation Of Compensation Amount - Mitsubishi Electric M700V Series Programming Manual

12. Tool Compensation Functions

12.4.9 Diameter Designation of Compensation Amount

Function and purpose
With this function, the tool radius compensation amount can be designated by tool diameter. When
the control parameter "#8117 OFS Diam DESIGN" is ON, the compensation amount specified to
the commanded tool No. will be recognized as the diameter compensation amount, and the
amount will be converted to the radius compensation amount when executing the compensation.
Operations when designating the compensation amount with diameter
(1) When the tool radius compensation amount D=10.0 is commanded, tool radius compensation
amount "d" is 5.0 if the parameter "#8117" is ON (set to "1").
(Tool radius compensation amount "r" is 10.0 if the parameter "#8117" is OFF (set to "0").)
(a) Linear to linear (acute angle)
Program path
d
Tool center path
(When #8117 is ON)
Φ20 tool
Outside of the corner
Tool center path
(When #8117 is OFF)
r
s
Tool center path
d
(When #8117 is ON)
θ
Program path
d
r
12.4 Tool Radius Compensation
θ
d
s
d
214
r
Program path
Tool center path
(When #8117 is OFF)
Φ20 tool
Inside of the corner
Program path
r
Tool center path
(When #8117 is ON)
Tool center path
(When #8117 is OFF)
r